I think its GREAT.
I like the bed and think it a good value for the dollar. It is advertised as being antislip because of the height of the side rails being such that a mattress would fit and not slid off of the frame. This is great.
It was easy to assemble, and I like the headboard. I have a foam TUFF AND NEEDLE mattress, and just my opinion, it might be nice if the rails were about an additional 1/4 higher for a snug fit with this type of mattress.
Then again, I placed a 1/4 piece of plywood left over from the old bed and placed it on the slats and this took a little of the height of the rails away. Maybe its fine the way its manufactured. Also I like that the middle legs are firmly reinforced / attached to the frame. This I am sure prevents the middle legs from collapsing. The mattress fits fine but my druthers is that if this were rail were higher I would like it that much more, and the addition of the 1/4 plywood would be accounted for. And as an addition to the bed I used a piece of the old bed (3/4 x 14 x 40) (Ameriwood) to mfg a actual headboard. I drilled a hole in the cornors and used some zip ties to attach to the uprights as a headboard (pillow does not slip thru the crossmembers of the headboard). Really not needed, but adds a little something to it. I could have attached it with some screws but preferred the zips.
In summary this is a great buy and should last may years. Built strong.
Great buy for the money
I think its GREAT. I like the bed and think it a good value for the dollar. It is advertised as being antislip because of the height of the side rails being such that a mattress would fit and not slid off of the frame. This is great. It was easy to assemble, and I like the headboard. I have a foam TUFF AND NEEDLE mattress, and just my opinion, it might be nice if the rails were about an additional 1/4 higher for a snug fit with this type of mattress. Then again, I placed a 1/4 piece of plywood left over from the old bed and placed it on the slats and this took a little of the height of the rails away. Maybe its fine the way its manufactured. Also I like that the middle legs are firmly reinforced / attached to the frame. This I am sure prevents the middle legs from collapsing. The mattress fits fine but my druthers is that if this were rail were higher I would like it that much more, and the addition of the 1/4 plywood would be accounted for. And as an addition to the bed I used a piece of the old bed (3/4 x 14 x 40) (Ameriwood) to mfg a actual headboard. I drilled a hole in the cornors and used some zip ties to attach to the uprights as a headboard (pillow does not slip thru the crossmembers of the headboard). Really not needed, but adds a little something to it. I could have attached it with some screws but preferred the zips. In summary this is a great buy and should last may years. Built strong.